The Rayport ballasted mount for flat roof commercial installations is made from all stainless steel parts, providing best-available corrosion protection in every environmental condition. Extensive engineering and loading analysis from AETs product design group help to provide a low-cost, high-quality product that minimizes assembly time. Rayport ballasted roof mounts can be used with any module that are between 31.8" and 39.1" wide. Modules are mounted in a landscape orientation, at a 10 degree angle. Installed dimensions are module length x (number of modules per row) east to west by 58.65 inches x (the number of rows)
Rayport mounts are wind tunnel tested to 120 mph.
Integrated fasteners and built-in WEEB grounding between the modules and the frames allow for quick, easy installation.
Parts required
A mounting system includes module support rails, ballast pans, module clips, bolts and ground lugs. If you consider modules running north to south as columns and modules runnning east to west as rows, you will need the following:
- Number of module supports = number of modules x 2
- Number of modules clamps = number of modules x 4
- Number of ballast pans = (number of columns + 1) x (number of rows + 1)
- Number of bolts = (number of ballast pans + number of modules) x 4
Contact us for help with the required ballast which will depend on building height, module type and exposure category. We can provide that informations and help with final system design.